ANITA ©
MP00006EN_181206
52
39 Barcode position Y (0,1 mm)
Position of barcode Y
-½ to ½ sewing range Coordinates for position X, where barcode is situated. This parameter is only
used for machines equipped with barcode reader and for barcode mode 2
or 3.
40 Heat trim start position
0 to 2400
When parameter
15 Trim
is set to value
2 Heat trim
:
Position of needle when knife start moving.
When parameter
15 Trim
is set to value
4 Stepper cam
:
The value is rotation speed of stepper motor in thread trim process
(movement speed, when needle has position from parameter
42
to thread
trim). Default value for machine GPS/H-0504 is 10. Lower value mean high
speed (2 = maximum speed, 25 = minimum speed).
41 Starting time of thread feeder
0 to 2000
When parameter
15 Trim
is set to value
2 Heat trim
:
Period between start of heating and contact of thread with the heat knife.
When parameter
15 Trim
is set to value
3 Pneumatic trim
:
Position of needle when knife catch threads. (default value is 500 for shuttle
hook and 550 for rotary hook)
When parameter
15 Trim
is set to value
4 Stepper cam
:
The value is position of needle when knife catch the thread.
42 Operating time of thread
feeder
0 to 2000
When parameter
15 Trim
is set to value 2 Heat trim:
Period between contact of thread with heat knife and release of thread from
heat knife.
When parameter
15 Trim
is set to value 3 Pneumatic trim:
Position of needle when knife cut (trim) threads. (default value 100)
When parameter
15 Trim
is set to value
4 Stepper cam
:
The value is position of needle when knife start movement for trim the
thread. You can set the movement speed by parameter
40
.
43 Winding counter
Optional equipment for setting of exact amount of thread to be
wound
0 Disable
Equipment for adjustable amount of thread is not connected (default)
1 Enable
Equipment for adjustable amount of thread is connected
2 Signal B
Set output to Signal B mode. Signal B mode allows setting Signal B level in
pattern programming. It is for user’s option device. For example: User of
machine can use the Signal B for special holder of material.
44 Thread pulling-out
0 to 800
Position for activation of thread pull-out
www.garudan.cz
Summary of Contents for GPS/G-10060
Page 69: ......
