ANITA ©
MP00006EN_181206
38
10.4
Insertion (deletion of command for setting of presser foot height (for
series GPS/H):
Command for setting of presser foot height can be used on all models of series GPS/H. Presser foot
mechanism controlled by step motor enables machine to change height of its presser foot in defined
position. The operator can sew parts of one pattern with various thicknesses of material smoothly
and without any interruption in positions where the thickness changes. It is possible to programmed
precise steps and corrections in the height of presser foot for any selected position during sewing,
also in correlation with the machine speed.
For insertion of command for change of presser foot height, proceed according to following
instructions: open list for selection by pressing arrow next to D12 and choose item
Point
. This way list
of individual points is activated. Click the point for change of presser foot height on the screen.
Selected point will turn red. Then click on E5 to connect the command with the selected point. Then
the window is opened where you choose height of presser foot in mm. After confirmation you can
see selected point marked with inscription PP + Up or PP-Down, indicating increase or decrease of
presser foot height in mm.
Deletion of command is realized the same way as deletion of command for trimming – by the button
E7 (see chapter 10.2) or by setting the change of presser foot height at 0.
www.garudan.cz
Summary of Contents for GPS/G-1507
Page 69: ......
