ANITA ©
MP00006EN_181206
44
12.
PARAMETERS OF MACHINE
Parameters of machine you can set in Parameters mode. This mode you can activate only if the
service interface is active (chapter 6). By pressing key A4 – Parameters you switch over to this mode.
The window of this mode is made by three parts. On left side there is the list of parameters. These
parameters you can set by pressing on menu bar (combo box) or set concrete numeric value by the
help of keyboard on the right side. In the middle of the screen there is the scheme. This scheme is for
settings two options of sewing speed acceleration. On right side there is the keyboard B for setting of
numeric values of machine. Setting is done by pressing the parameter. When the parameter turns
red you can set the value by the help of keyboard. After that you can confirm changes by pressing
Save and Apply
on right side of the screen. If you don´t press this key changes won´t be saved and
activated. Right green arrow A switches to next page of parameters.
Parameters are possible to backup or restore to USB pen drive or to memory of machine. Backup and
restore functions are under button
Backup or restore param
(button C on picture 23).
Picture 23: List of parameters
www.garudan.cz
Summary of Contents for GPS/G-1507
Page 69: ......
