ANITA ©
MP00006EN_181206
51
34 Programmable presser foot
0 Disable
OFF – programmable presser foot is not installed (default).
1 Enable
ON – programmable presser foot is installed.
35 Reverse angle before wiper (°)
Angle of reverse motor movement before thread wiping
0 to 30
Angle by which needle motor moves back before thread wiping. (default
value is 0)
(This parameter is available only for firmware 0,25 and higher)
36 Bobbin counter method
Ways of checking amount of lower bobbin
0 Pallets
Number of pallets is counted. After defined amount of pallets is reached, the
machine is blocked and will not enable sewing of following patterns.
Unblocking the machine is made by pushing the button on the screen
1 Stitches 1
Number of stitches is counted. After defined amount of stitches is reached,
sewing will stop immediately (machine will stop in the middle of unfinished
pattern). For continuation of sewing, it is necessary to push the button on the
screen.
2 Stitches 2
Number of stitches is counted. After machine calculates that there will not be
enough thread to be able to finish next pattern with defined amount of
stitches, machine will not start to sew next pattern (machine is blocked
before start of sewing).
37 Barcode reader
Ways of working with barcode reader
0 Disable
Barcode reader is not on the machine, its functions are blocked
1 Manual
Manual – It is necessary to place feed plates manually under barcode reader
2 Position
Position – Barcode has fixed position on feed plate, machine moves to correct
position before start of sewing – position is defined by parameters 38 and 39.
3 Stay on position
Fixed position- Barcode has fixed position on feed plate, machine starts and
finishes sewing operation on position defined by parameters 38 and 39.
4 Automatic
Automatic – after barcode is loaded, sewing pattern is automatically changed
after operator confirms the change
5 Automatic NoConf
Automatic change without confirmation - after barcode is loaded, sewing
pattern is automatically changed
6 Pallet changer
Exchange of pallet – mode for machine equipped with mechanism for
exchange of pallet
38 Barcode position X (0,1 mm)
Position of barcode X
-½ to ½ sewing range Coordinates for position X, where barcode is situated. This parameter is only
used for machines equipped with barcode reader and for barcode mode 2
or 3.
www.garudan.cz
Summary of Contents for GPS/G-1507
Page 69: ......
