ANITA ©
MP00006EN_181206
53
45 Pattern copy in operator mode
0 Disable
Operator cannot copy patterns to machine and from machine to USB pen
drive. Transfer of patterns is only possible in service mode.
1 Enable
Operator can copy patterns to machine and from machine to USB pen drive.
Transfer of patterns is possible in both modes.
46 Needle bottom position
min.
10 to 300
Position of needle until which the needle is considered as being above
material and where the machine starts to report that needle is inside the
material. If thick material is used, it is necessary to lower the value, for light
materials it is possible to increase the value (default value is 300).
47 Needle bottom position
max.
550 to 790
Position of needle until which the needle is considered as being above
material and where the machine starts to report that needle is inside the
material. If thick material is used, it is necessary to increase the value, for light
materials it is possible to lower the value (default value is 550).
48 Offset X
From -½ to ½ of
sewing area (in 0,01
mm)
Offset of zero point of machine in axis X. This is value of position of zero
position sensor n axis X. (default value 0)
49 Offset Y
From -½ to ½ of sewing
area (in 0,01 mm)
Offset of zero point of machine in axis Y. This is value of position of zero
position sensor n axis Y. (default value 0)
50
Mechanic password
0 to 99999999
It is possible add new mechanic password for access to service mode. This
parameter will be new password for access to service mode. Normal
password 67976 will be still operating. Value 0 means that parameter is
disabled. (default value 110585)
51 Auxiliary tensioner
0 Disable
Auxiliary tensioner (optional device) is not on machine. (Default value)
1 Enable
Auxiliary tensioner is on machine. It is possible add command in pattern
programming.
www.garudan.cz
Summary of Contents for GPS/G-1507
Page 69: ......
