18
D
、
Operating Instructions
1) While pushing the control knob, turn it to the left (towards the
“
On
”
position)
slowly until you hear a
“
Click
”
sound. Electronic spark will ignite burners.
Keep pushing the control knob for several seconds, the safety device will
then operate. If you release your hand halfway, electronic spark might not
ignite burners.
2) If the flame goes out when you release your hand, repeat the ignition
procedure again but try release your hand slowly.
3) Turn control knob to adjust flame to desirable setting. Flame can be adjusted
between
「
」
and
「 」
. Please adjust flame slowly
【
illustration 3
】
.
4) If the flame is extinguished while using, the safety device will shut the gas off
after a short delay. When this happens, please turn the control knob to
“
Off
”
position.
5) Turn the control knob backwards to the
“
Off
”
position to extinguish the
burner.
E
、
Replace Battery
When the sound generated from ignition spark becomes deep, or the ignition
may light up flame but would be extinguished instantly, please replace the
battery. Also, please set battery at correct polarity (
“
+
”
and
“
-
“
).
