Engine Assembly
149
CYLINDER HEAD
Attach the centering pins (1) and a new cylinder-
head gasket (2).
CAUTION!
Use a new cylinder-head gasket, to prevent petrol
leaks.
With the cylinder head properly settled on the
cylinder, secure the cylinder head by tightening
the screws in a diagonal sequence. Tighten the
cylinder-head screws at the specified torque.
Cylinder-head screw:
Initial: 25 N, (2.5 kgf-m)
Final: 46 N, (4.6 kgf-m)
NOTE:
Apply motor oil to the threaded areas of the cylinder-
head screws and their washers.
Position the washers with their rounded faces
upwards.
After tightening the cylinder-head screws at the
specified torque, tighten the cylinder-head screws
(1) and the cylinder screws (2) at the specified
torque.
Cylinder-head screw: 10 N, (1 kgf-m)
Cylinder screws: 10 N, (1 kgf-m)
Tighten the cylinder-head side screw (3) at the
specified torque.
Cylinder-head side screw: 14 Nm (1.4 Kgf-m)
1
2
1
3
2
!
!
!
!