Owner's Manual
-52-
Maintenance
34.-fuel SySteM
check the status of: The rubber of the tank cap, the tank cap, the tank breather
tube and the tank.
35.-SteerinG HeaD aDjuStMent
The steering should always be adjusted so that the handlebar rotates freely, but
without play.
To check the steering adjustment, lift the bike off the ground, using a bracket
under the chassis. move the handlebar gently to each side, if when letting go of the
handlebar it continues to move by itself, it means that the steering is not too tight.
squat down in front of the motorcycle, grip the lower part of the front fork (in the
shaft), push and pull the fork (1). if there is play, the steering is too loose.
if the steering must be adjusted:
1. stabilize the motorcycle with the stand or with a special bench.
2. keep the front wheel from touching the ground.
3. Remove the handlebar by loosening the screws on the handlebar clamps (2)
and removing the upper flanges.
4. Loosen the steering axle nut (3).
5. Turn the steering nut (4) with the special wrench to obtain a suitable
adjustment.
6. Tighten the steering axle nut.
7. Recheck the steering and reset if necessary.
8. install the disassembled parts.
2
1
3
4
Summary of Contents for Enduro 2T 250 2018
