-
52
-
WARNING
Wait for the bulb to cool before removing it. 3. lnstall
a new bulb to the bulb holder.
4.Reinstalll the cover and headlight cover. Ad-just the
headlight beam if necessary.
Spark arrester cleaning
Select a well-ventilated area free of combustible
materials and make sure the exhaust and silencer are
cool.
1. Remove the bolt.
2. Start the engine, block the end of sillencer with a
dowel, which will increase the speed about twenty
times by momentarily producing exhaust system back
pressure.
3. Stop the engine and cool the exhaust pipe.
4. lnstall the bolt and tighten it.
CLEANING AND STORAGE
CLEANING
General speaking thorough cleaning of your QUAD
Will improve its runing performance and prolong the
service life of many components.
1. Before cleaning the QUAD:
a. Block off the exhaust pipe with plastic bag or strong
rubber band to prevent water entry.
b. Make sure the spark plug and all filler caps are
properly installed.
2. If the engine case is excessively dirty.wash with
degreaser. Do not use degreaser for wheel axles.
3. Rinse the dirt and remove oil dirt on the soft hose.
CAUTION
Excessive water pressure may cause water
seepage and deterioation of wheel bearings, brakes,
transmission seals and electrical equipment.
4. When rinsing dirty material for many times, use warm
water and mild, detergent-type soap. Use old toothbrush
or bottle brush to wash hard -to-get-at places.
5. After cleaning QUAD with clean waterimmediately
dry all surfaces with a chamois clean towel or soft
absorbent cloth.
Summary of Contents for K2 QUAD 250 - SERVICE
