8
HOW TO
INSTALL SUBWOOFER
The MAD S1-104/S1-124 uses a single 4 Ohm voice coil. If you want to connect two or more
S1 series subwoofers, you can vary the impedance by altering the wiring configuration to
use a series, parallel or series-parallel setup. The more the merrier!
Before installing your brand new subwoofer, make sure that you have everything you need.
Have the right tools ready, and make sure that you have the necessary knowledge/skill to
perform the installation properly. Preparation and knowledge is crucial!
One 4 Ohm subwoofer
@ 4 Ohm
Two 4 Ohm subwoofer
@ 8 Ohm in series
Two 4 Ohm subwoofer
@ 2 Ohm in parallel
It is important to
know the limits of
your amplifier. Be sure
to connect your sound
system with a suitable
impedance to optimize
your sound system.
Make sure to look through the recommended wiring schematics below and choose the
setup that corresponds with the number of subwoofers in your sound system. Take note of
the impedance stability of your amplifier. Don’t be afraid to consult your local GAS AUDIO
POWER dealer/installer if you have any questions.
Summary of Contents for Mad S1-104
Page 1: ...MAD MADE TO PLAY LOUD MAD S1 104 S1 124...
Page 16: ......
