Page 5-4
MDE-4334C Atlas Start-up and Service Manual · April 2008
Pump Programming
Configuring the 9800 Series
Mechanical Commercial Units
The 9100 and 8700 Series units use a mechanical computing device. Prices are set on the
mechanical units by adjusting the Variator. Besides the instructions in this manual there are
instructions on the base of the Variator assembly also.
Figure 5-3: Mechanical Commercial Display
Atlas
TURN OFF ENGINE
Total Sale
Gallons
Total Sale
Gallons
Configuring the 9800 Series
The 9800 Series (Electronic Commercial) can be configured for various operating conditions
by setting the switch(es) and jump jacks (if applicable) located on the CPU Printed Circuit
Assembly (PCA).
General Configuration Details
The 9800 series units can be configured for various operating conditions using the switch(es)
and jump jacks (if applicable) located on the CPU PCA. Check these switch(es) and jump
jacks (if applicable) and change their settings, if necessary. Switch and jump jack (if
applicable) settings should be changed only when power is shut off. The new settings are read
by the CPU PCA when power is restored.
To change the switch and jump jack (if applicable) settings, access the CPU board by
removing the front panel, then remove the screws shown in
on
.
