-10-
(Pos. 2, former shaft overview) are exposed. Once the desired weight has been found, select the
automatic mode and press the green start button again.
Image 4, Position of the plate
7. If the patties are seen to come out with a layer above the plate or they are not well compacted, this
can be adjusted using the weight calibration gear. Turn it a few degrees to the left or right until the
mark on the gear lines up with the grooves on the protection.
Image 5, calibration 1
Image 6, calibration 2
8. To extract the patties, use the slice designed for this purpose, sliding it over the plate (Pos. 12,
overview), keeping it completely flat.
The slice must be kept clean at all times. We recommend providing a container with water to wet
the slice and keep it damp during this process.
