7
QUICK START GUIDE
1. Install filters and tubing included if necessary.
2. Turn the meter ON by switching the red power switch up on the left of the device.
3. Turn logging ON by pressing the PUMP button until the SD Card Icon displays a
green
inner square.
When the sampling process is completed, you can hold the PUMP button until the SD Card Icon
turns solid
white.
4.
When the SD Card is White, the pump will stop after 60 seconds of sampling. (user is able to
set the sampling period to any time length).
POWERING THE METER
1. Power on: Switch the Red Power Button ( A ) Up, located on the left side of the device, to the UP position.
2. To turn off, Switch the Power Button ( A ) Down.
3. This device uses Li‐ion rechargeable batteries, which can provide a 30+ hours charge.
*Please note - when the device is charged with a USB cable it cannot be turned off*
OPERATION
The red POWER switch on the left side of the device turns the unit ON/OFF. The PUMP button on the right side of the
device’s faceplate, enable/disable the pump/or logging functionality.
Make sure you read through these instructions thoroughly before using the device. This guide will help you become
more familiar with the device’s operation. Please read the
Important Safeguards
on page
3
before continuing.
IMPORTANT: Follow these instructions to ensure proper set up:
1.
After powered on, when pump is activated, the device will measure the data in real‐time.
2.
Before getting started you need to enter the settings screen, by holding the
Mode Button (I),
to alter the settings
of the device
.
3.
Utilize the
UP
and
DOWN
arrow buttons to highlight the appropriate settings you wish to update. Once selected,
the appropriate setting will be highlighted in
purple
and can be altered by using the
UP
and
DOWN
buttons.
Once the appropriate settings have been selected, press and hold the
MODE
button to return to the main display
screen.
*Please note, you may wish to navigate to "auto power off" and "back‐light time" in the settings screen to
change the standard 30 second time / 60 minutes period to any custom length interval for non‐
interference*
On the main display you will notice 3 zone squares:
‐
Zone 1
(top display sensor area)
Zone 2
(bottom left ‐ RH) and
Zone 3
(bottom right ‐ DP/AL/AMB)
1. To select a zone, use the
Left (F) / Right (G) arrow buttons
to select the parameter/ sensor to
be adjusted, the zone will be highlighted in
red
.
2.
Next, you can press the
Right arrow button (G)
to proceed to alter the settings use the
Up (E) /Down
(H)
arrow buttons to edit the parameter values or alarm levels for that zone.
DISPLAY ALL SENSOR READINGS
•
Press/hold the
ENTER
button ( J ) to display all sensor readings. Press the
MODE
button ( I ) to return to
the main screen. (See reference chart below, for factory default settings.
