FOLD
FOLD
FOLD
FOLD
IMPORTANT
Read these instructions for use carefully. Familiarise yourself with the appliance
before connecting it to it’s gas container. Keep these instructions for future reference.
This appliance shall only be used with a Butane gas cartridge certified to EN 417 or equivalant.
IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CONTAINERS.
* REMOVE ANY TRANSIT PROTRECTION MATERIAL.
WARNING
NEVER USE A POT OR PAN OVER 20CM DIAMETER.
PARTS LIST
3. Push the Cartridge Lock down to ‘LOCK’ in
one firm motion (Fig. 3).
WARNING
THE OPENINGS AT THE BASE OF THE BURNER PROVIDE AIR FOR COMBUSTION,
THEY SHOULD NEVER BE OBSTRUCTED. IF THE FLAME BECOMES SIGNIFICANTLY
ORANGE CHECK THESE OPENINGS FOR A BLOCKAGE.
IF THE APPLIANCE CANNOT BE ADJUSTED TO PERFORM CORRECTLY IT SHOULD
NOT BE USED UNTIL SERVICED OR REPAIRED.
TO START
INSERTING THE GAS CARTRIDGE
1. Turn the Ignition Knob to ‘OFF’ and
set the Cartridge Lock lever to ‘OFF’.
(Fig. 1)
Note: If the Ignition Knob is ‘ON’ the gas
cartridge cannot be loaded into the cooker.
2. Open the Cartridge Cover: slide the gas
cartridge, top end first and with its notch
up, into the compartment. Align cartridge
collar notch with the locator tab on the
appliance. (Fig. 2)
Fig. 1
Fig. 2
Check that the seals between the appliance
and the gas container are in place and in good
condition before connecting the gas container.
• DO NOT use this appliance if it has damaged
or worn seals.
• DO NOT use this appliance if it is leaking,
damaged or does not operate properly.
TO SHUT OFF
1. Turn the Ignition Knob to ‘OFF’ to shut off fuel supply
(Fig. 5). Wait until the flame is fully extinguished
before performing the next step.
2. Raise the Cartridge Lock Lever to ‘OFF’ and
remove the gas cartridge from the compartment.
Note: Do not leave the gas cartridge inside
the unit when not in use.
Fig. 4
HANDLING WHEN THE AUTOMATIC SAFETY
SHUT-OFF DEVICE IS ACTIVATED
•
When used in high temperature areas, such as the beach during summer, the internal pressure of the
cartridge may rise to more than 7Kg/cm
2
(normal pressure = 3-4Kg/cm
2
). This will activate the
Automatic Safety Shut-off Device inside the regulator.
•
Remove the Gas Cartridge from the compartment. Push the nozzle inward to release internal
pressure and place in a cool or shady area.
•
Turn the Ignition Knob to ‘MAX’ to release any excess gas inside the regulator. Repeat the 3 steps for
inserting the gas cartridge after it has cooled down.
AFTER USE
1.
Replace the cap on the gas cartridge after removing it from the unit. Store upright in a cool dry
place.
2. Make sure the burner is cool to touch before packing unit away.
3.
DO NOT
store the cartridge near other flammables.
DO NOT
store the cartridge near sources of heat or direct sunlight.
DO NOT
store in the glove compartment or boot of your car.
DO NOT
puncture or incinerate empty cartridges.
LIGHTING THE COOKER
1. Turn the knob anti-clockwise past the ‘HIGH’ position
until a click is heard.
2. If the burner fails to light, immediately turn the
Ignition Knob to the ‘OFF’ position and repeat Step 1.
TO ADJUST HEAT
1. Flame can be controlled by turning the Ignition Knob
between the ‘HIGH’ and ‘LOW’ position.
• The cartridge may be disconnected even if some gas remains.
• Check the contents by shaking and listening for the liquid gas.
Gas containers shall only be changed in a well ventilated location, preferably outside, away from
people
and way from sources of ignition; such as naked flames, pilot flames, electric heaters/equipment.
If there is a leak on your appliance (smell of gas) and you cannot stop the gas flow, remove the
appliance to a well ventilated location away form any ignition source. Only check for leaks outdoors using
soapy water. DO NOT try to detect leaks using a flame.
This appliance must only be serviced by an authorised person.
Fig. 3
Fig. 5
OFF
HIGH
LOW
W
ARNING
THE CONTROL KNOB
MUST BE
“OFF”
BEFORE
LO
ADING THE C
AR
TRIDGE
ON
OFF
OFF
HIGH
LOW
OFF
HIGH
LOW
W
ARNING
THE CONTROL KNOB
MUST BE
“OFF”
BEFORE
LO
ADING THE C
AR
TRIDGE
ON
OFF
OFF
HIGH
LOW
