7
6
INSTALLATION
Step 1
Insert Lower Tube (9) into Base (10) ensuring
that tab on Lower Tube slots into hole in Base.
Carefully turn the Base/Lower Tube assembly
upside down and secure Lower Tube to Base with
Washer (11) and “L” shaped screw (12). Please
tighten screw completely before moving on to next
step.
Step 2
Insert Middle Tube (8) onto top of Lower Tube
assembly, Lower Tube will slide inside Middle Tube.
Line up the screw holes in Middle Tube with screw
holes in Lower Tube. Secure with 2 x Screws (4)
and tighten.
Step 3
Release and extend out Upper Tube Extension
(5) from Upper Tube (7) by turning Adjustable
Fastener (6) counter clockwise. Once Upper Tube
extension is fully out tighten Adjustable Fastener
by turning clockwise. Insert Tube Extension into
the back mounting hole in Control Box (1). Secure
with Screw (13).
Step 4
Insert base of Upper Tube into top of Middle
Tube, Middle Tube will slide inside Upper Tube (as
step 2). Line up the screw holes in Upper Tube
with screw holes in Middle Tube. Secure with 2 x
Screws (4) and tighten.
Step 5
Clip power cord into Cord Clips down the back of
Upper/Middle and Lower Tubes.
Step 6
Heater head can be adjusted to various angles by
loosening and then tightening the screw on the
side of the Control Box as shown in Fig. C.
Step 7
The height of the Heater head can be adjusted by
turning Adjustable Fastener (6) counter clockwise
and adjusting the head to desired height. Then
tighten Adjustable Fastener by turning clockwise.
Step 8
Place 2x AAA batteries in Remote Control.
ASSEMBLY INSTRUCTIONS
Fig. A
Fig. B
Fig. C
Summary of Contents for GM135-010
Page 8: ...8...