Gasmate GM135-045, Manual

3

2

WARNING: Fire risk exists if this heater is covered or 
positioned close to combustible materials.
Always ensure you select the correct fixing 
accessories which suit the particular material you 
are attaching to, if in doubt please discuss with your 
local retailer or local hardware store. This heater is 
not designed for use within 1m or above a water 
source. All installations must meet the requirements 
of Australia Standard AS/NZS 3000:2007.
NOTE: When using this heater outside ensure that it 
is connected directly to an outdoor power point.
The electrical system of this heater must be 
connected with an automatic 30mA circuit breaker 
and/or residual current device (RCD). If uncertain 
have a qualified electrician check your electrical 
system before installation and/or use.
All electrical connections are made in a dry area.
Outdoor power points must be weatherproof and
installed by a qualified electrician.
The distributor is not responsible for incorrectly 
chosen additional fixing accessories or any damage 
which may be caused by an incorrectly fitted heater. 

FOR YOUR SAFETY

•  Do not twist, kink or wrap the cord around the 

heater as this may cause the insulation to weaken 
and split.

•  This heater is not intended for use by persons 

(including children) with reduced physical, sensory 
or mental capabilities, or lack of experience 
and knowledge, unless they have been given 
supervision or instruction concerning use of the 
heater by a person responsible for their safety.

•  Children should be supervised to ensure that they 

do not play with the heater.

•  This heater is intended for light domestic use and 

not for heavy duty commercial or industrial use.

•  The heater must not be located immediately 

below or in front of a socket-outlet.

•  CAUTION: In order to avoid a hazard due to 

inadvertent resetting of the thermal cut-out, this 
heater must not be supplied through an external 
switching device, such as a timer, or connected 
to a circuit that is regularly switched on and off by 
the utility.

•  Never remove the cover of the heater – in case of 

a fault contact a qualified service person.

•  Repairs should only be carried out by qualified 

persons using original spare parts. Failure to 
do so may result in considerable danger to the 
operator.

•  Use this heater only as described in this manual.
•  Any other use is not recommended by the 

manufacturer and may cause fire, electric shock 
or injury.

•  The remote control function is line of sight and 

may not operate if something or someone is in the 
way of the signal.

Installation

This heater is not designed for use within 1m or above a 
water source.
Ensure that the heater is not positioned directly above, 
below or in front of a power point or switch.
This heater is not designed to be used with 3rd party 
timer or programmable system.
This electric heater complies with New Zealand and 
International standards and safety requirements. All 
installations must meet the requirements of New Zealand 
Standard AS/NZS 3000:2007.

ELECTRICAL DATA

IMPORTANT

This product is fitted with a sealed electrical connection 
plug that is compatible with the heater, the mains 
supply for New Zealand and meets the requirements of 
international standards. This heater must be connected 
to a supply voltage that is equal to that stated on the 
rating label. 
If the mains connection plug or power cord becomes 
damaged it must be replaced with a complete assembly 
that is identical to the original, and this must be replaced 
by an authorised service centre. 
Always follow the New Zealand requirements for 
connection to the mains supply. If in doubt always 
consult a qualified electrician.

Technical Specification

Model

GM135-045

Voltage:

220V-240V~ 50Hz

Input Wattage:

2400W

Unit Weight:

4.1kg

IP Rating:

IP65

Heater specifications can be found on the data label.