Gasmate GM135-045, Manual

5

4

ASSEMBLY INSTRUCTIONS

For best results and your safety, please follow the 
instructions carefully. DO NOT modify this product in any 
way as the distributor will accept no liability for improper 
use.
Remove all package material (including anti-vibration 
object on the lamp) and check the heater, supply cord 
and plug for signs of damage.
Pay attention to the mounting place and all mounting 
material (dowels, screws). See figure 1. Ensure they are 
suitable and stable enough for mounting and holding the 
heater securely.
Before mounting, the minimum safe mounting distances 
and tilt angles shown in the figures below must be strictly 
followed.
• 

The distance between the bottom edge of the 
heater and the floor must be at least 1.8m. See 
figure 2.

• 

There must be a distance of at least 0.25m between 
the heater and the ceiling, roof or other overhangs. 
See figure 2.

• 

There must be a distance of at least 0.5m on each 
side of the heater and walls or the like. See figure 2.

• 

Recommended degree of tilt of the heater to the 
mounting surface is 45°. See figure 3.

Pay attention that the heater is not installed in 
excessively windy locations.
Fix the mounting bracket to the wall first. 
1. 

Take the wall bracket and select the position on 
the wall

2. 

Mark the holes for the wall bracket and drill

3. 

Using 4 suitable screws (not supplied) attach the 
wall bracket to the wall. Now assemble the wall 
bracket to the heater. 

Ensure that the place it is to be installed is secure and 
firm. Or connect the appliance to a stand (optional).
Adjust the desired angle of heater and tighten all screws. 
Check the screws are secure. Mechanical bearing 
pressure and oscillation due to wind or rain could lead to 
loosening.
Plug in to the power point and turn on. Then observe for 
the first 10-15 minutes that the heater works trouble-free.
If you do not use for an extended period, please remove 
batteries from the remote. 

Figure 2:

 Minimum distance to floor, ceiling and wall.

Figure 1:

 Mounting bracket and anchor dowels provided. 

Connection from the wall to the infrared heater.

Figure 3:

 Tilt angle.

45

°

0.5m

0.25m

1.8m

2.5M

4.6M

3.9M

COVERAGE AREA