Gasmate GSB300, Instructions Manual

18

IMPORTANT POINTS

PLEASE NOTE Upon receipt, your spit roaster will
be covered in a thin layer of oil which is used in
the manufacturing process, this needs removing
prior to

first

use with either hot soapy water or a

remover such as white spirit. If you don’t remove
this prior to getting the spit roaster hot on the

first

occasion, the burnt oil will tarnish the metal,

especially on the inside.
Avoid rubbing the printed ‘HOT’ areas on the spit
roaster with thinners or similar agents as they
may damage the printing.

Due to the heating and cooling of the spit 
roaster and vibrations caused by the spit 
rotations, some of the screws may become 
loose during transit or use. PLEASE tighten 
the screws periodically in particular the 4 
screws on the motor MUST be checked every 
time you cook as these are mounted upside 
down they are particularly vulnerable to 
becoming slack and a motor falling off could 
be a disaster half way through the cooking 
process.

Familiarise yourself with the spit to motor
connector and be careful not to lose the U 
shaped pin, you will

fin

d two holes on the motor

bracket where this pin can be stored when not
in use.

8

Step 8

Battery Insert

Take out the ignition button, inserting 1 pc of AA
battery.