6
7
6
6
ASSEMBLY INSTRUcTIONS
Note: Remove any transit protection material.
Tools required
Adjustable spanner.
Step 1
1-1.
Put the 3 post brackets on each position on
the base as shown in the picture.
1-2.
Use 3 M8 x 16mm bolts to join the post
brackets and base.
Step 2
2-1.
Put the base post on the top of 3 post
brackets.
2-2.
Use 6 M6 x35mm bolts and nuts to
connect the post to the post brackets.
Tighten the bolts and nuts.
2-3.
Fill the plastic container in the base with
sand.
2-4.
Attach the top post using 4M6 screws.
Step 3
Place the cylinder housing on the stand.
Step 4
4-1.
Secure the 3 90mm pins (reflector support
bolts) on the cap of flame screen.
4-2.
Route the gas hose up through the post
and out of the top.
4-3.
Connect the gas hose to the gas burner
inlet connector.
4-4.
Connect the regulator to the hose and a
gas cylinder and leak test both of the
connections using a soapy water solution.
4-5.
Attach the completed burner to the post
with 4 M6 x 10mm bolts.
Step 5
5-1.
Place a washer on each reflector support
bolt.
5-2.
Fasten the reflector with 3 washers and 3
M8 castle nuts.
1
2
3
4
5
