4
5
PARTIAL ENCLOSURES
INSTALLATION POSITIONING
SETTING UP YOUR OVEN
INSTALLATION GUIDE
• Place a soft matt or rug down to protect the
exterior of your pizza oven during the setup
process
• Remove all packaging elements
• Place your pizza oven with the top facing
downwards on to your matt/blanket. Whilst
the pizza oven is standing on its top, open
the three folding legs outwards
The appliance shall only be used in an above ground, open air situation with natural ventilation, without
stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and
natural convention.
WARNING
• Do not use the gas pizza oven in enclosed or on small balconies.
• Any enclosure in which the appliance is used shall comply with one of the following:
• This appliance shall only be used in an
above ground open-air situation with natural
ventilation, without stagnant areas, where
gas leakage and products of combustion
are rapidly dispersed by wind and natural
convection. This appliance must not be
used indoors. Do not use your appliance in
garages, porches, sheds or other enclosed
areas. The appliance should not be placed
close to or under any surfaces that will
burn or are sensitive to heat. Do not block/
obstruct the flow of air and combustion
around the appliance housing while in use
• A fairly protected location is desirable for
pleasant and efficient cooking. Try to keep
the pizza oven sheltered from strong winds
as this will drastically reduce cooking
efficiency. If this is unavoidable, position the
appliance to face away from the direction of
the wind. Keep the appliance level. Check
frequently that the burner remains alight
when used in conditions of strong wind.
Make sure the minimum distances of the
appliance to any wall or combustible surface
are met, and that the supporting surface can
withstand heat. When using the appliance,
take care that the appliance feet are locked
in their correct open position & the hose is
not touching any hot surface.
• Stand the oven upright on its legs and
remove the soft matt/blanket as this is no
longer required. Insert the pizza stone into
the appliance base as shown below and
slide it into the holder
• Unscrew the black electronic ignition and
insert a compatible battery (1 x AA) inside.
Re-screw the cover back on. This will
be used to ignite your appliance. Note:
Regularly check your ignitor battery to
ensure if has charge and replace when
required. The AA Battery is not suppliedwith
the appliance
• Connect your gas hose to the valve, visible
at the rear of your pizza oven (just below the
control knob). Follow the Gas Connection
steps outlined within this user manual.
Within a partial enclosure that includes an
overhead cove and no more than two walls.
A common example is an outdoor gazebo.
The appliance may be within a partial enclosure
that includes an overhead cover and more than
two walls, the following shall apply:
• At least 25% of the total wall area is
completely open; and
• At least 30% of the remaining wall area is
open and unrestricted.
An enclosure with walls on all sides but at
least one permanent opening at ground level.
In the case of balconies, at least 20% of the
total of the side, back and front wall areas
shall be and remain open and unrestricted.
A bonus pizza
spatula is included
