Tools Required
Phillips head screwdriver
2 Adjustable spanners
Note: Remove any transit protection material
STEP 1
Secure the post onto the post support with 6
screws, feed the hose up through the post and
temporarily secure the end with tape to the post
top.
STEP 2
Slide the cylinder cover over the post.
STEP 3
Secure the 3 reflector mounting studs to the
burner head assembly.
STEP 4
Feed the hose down the post. Secure the burner
head assembly to the post using the 4 bolts and
washers.
STEP 5
Connect the regulator to the hose and tighten
using 2 spanners.
STEP 6
Connect the regulator to a gas cylinder and leak
test the hose connection, then attach the burner
head to the post with 4 screws.
STEP 7
Place 3 washers onto the reflector mounting
studs, position the reflector. Then place 3 more
washers and secure with 3 nuts.
PATIO HEATER ASSEMBLY
Nuts
Washers
Washer
Bolt
Bolt
Washers
Washer
6
Summary of Contents for STELLAR BLACK PH7056
Page 9: ......
