STORAGE AND CLEANING
Page
136
05/06
To maximize the life of the seeder it is
suggested
that
basic
cleaning
and
protection of some areas of the seeder is
performed after each season.
1.
Empty all bins of fertilizer and seed.
2.
Release oil pressure in hydraulic
hoses when disconnecting breakaway
fittings (refer page 116).
3.
Wash the inside of the bin and
meterbox with warm soapy water to
clean any fertilizer or toxic residue that
may have been left. Flush with water
and thoroughly dry before sealing the
compartment area.
Note: Take care
not to spray water directly at the
bearings and shaft seal
4.
Wash the outside of the seeder to
reduce the possibility of rust and to
extend the life of the paint.
5.
Grease and generally apply lubrication
to all moving parts where practical.
Lubricate chains with a suitable chain
lubricant. Place grease or some form
of rust inhibitor on the variator shafts.
6.
Plug primary distribution hoses on
seeder and fit the supplied cover
plates to the implement to prevent
infestation of pests.
7.
Inflate tyres to maximum
recommended pressure before
storing.
8.
If the seeder is to be stored outside,
place covers over the tyres, hoses
and blower intake to reduce the
effects of weathering.
9.
Loosen the bin lid and meterbox hatch
to allow the seals and gaskets to
recover.
10. Chock the wheels to prevent seeder
moving.
Preparing the Seeder for Operation
To prepare the seeder for operation after
storage refer to the Maintenance Sections
–
‘Pre-Season Checklist’ on page 128.
Fig. SC1 1880RT air seeder with CT (controlled traffic) option.
