ASSEMBLY INSTRUCTIONS
10/09
Page 20
Seeder to Implement Hitch to Suit
1860RT
–CTC (Control Traffic Castor)
The implement hitch on the CTC
model seeder must be mounted at the rear
of the bar. The 2 extension beams that
protrude rearward can be spaced to clear
tines and other implement structure but
should be symmetrical about the implement
centre-line.
The cross beam can then be bolted to
the extension beams. The ‘A’ frame pull is
pinned in 2 places to the cross beam. The
spring mechanism should be fitted to hold
the ‘A’ frame pull off the ground to allow the
implement to be manoeuvred without the
seeder attached. (refer Fig. A5).
The extension beams may require
some modification if being fitted to a non-
Gason implement. It is important that the
extension beams are securely fastened at
both the rear row of the implement and one
row forward as shown in Fig.A5. Extension
beams are also available to suit the CT2
Gason implement.
Fig.A5 1860RT-CT Implement Hitch.
