-2-
The polarity of the connection lead is marked on the label of the unit. In the case of
using reversed gears, the connector should be connected backwards to reverse the
operation of the motors.
Brake connections
Connect the leads from
brakes on the sockets
labeled “Brake”. Polarity and
position are not important
on the brakes.
You can use good quality JR
extension leads for the
motors and brake leads if
necessary.
Battery connection
Battery should be connected on the yellow MPX connector. Double check the correct
polarity before connecting the battery on the unit, a reversed battery connection will
destroy the unit, often the damage is beyond repair.
Output for the door servos
Connect the 3 servos to the outputs on the unit. You can connect more than one servo
to each output using a “Y” lead.
Output to the steering servo
Connect the steering servo to “Steer Out” if used.
Radio inputs:
You can choose to use a single channel to control the gear and brake, or separated
channels. Gear input channel should be always connected for operation, brake channel
and steering input channel are optional.
Power supply considerations:
PLEASE READ!
This controller can receive up to 3 different power sources. In order to prevent
malfunctions in your system you should know that:
The main battery should be between 6,6 to 9,9V. Recommended battery is a Lipo of
7,4V. Please double check the polarity before connecting it. The damage caused by
polarity reversal is not covered by warranty!!!
Picture 2
