USE AND MAINTENANCE
53
ENGLISH
g
cod. G19502661
3.2.4 FITTING OF DRIVE BELTS
This operation should be carried out with the tractor engine
switched off, the parking brake on and the equipment resting
on the ground.
1) The belts should be inserted between the pulley fitted on the
rear power take-off of the harrow (A, Fig. 16) and the one with
the centrifugal clutch of the blower (B, Fig. 16).
2) Regolate belt-tension using handwheel "A" ( Fig. 17).
Press on the middle part of the belt be- tween the two pulleys
with a 5 Kg force. Each belt should give max. 1 cm (Fig. 18).
To change belts remove belt tension completly with using
handwheel. (A Fig. 17).
Caution: Never take off nut "B"! (Fig. 17)
The belts should always be replaced in pairs, using original
spare parts.
If a blower rotation speed (rpm) sensor is fitted it will be
necessary to check that it positioned correctly in front of
the reading area (see supplementary instruction booklet).
If required, loosen the screws (B) and move the sensor
support (A, Fig. 19).
3) After the V-belts have been fitted, check their correct alignment
between the drive pulley and the driven pulley.
Precise alignment makes the belts run smoothly and last
longer.
4) Put back the guards of the pulleys and the belts (A, B Fig. 13),
making sure they are positioned and secured properly.
fig. 19
B
A
fig. 17
B
A
fig. 16
fig. 18
5 kg
1 cm
A
B
Summary of Contents for ALIANTE DD
