5
© 2023, JUN-AIR
We reserve the right to make any alterations which may be due to any technical improvements
Printed in the USA
106R Cabinet Systems User Guide
6190759 (Rev B)
OPERATION
•
If the compressor has been stored at an extremely low
temperature, allow it to heat to room temperature before
switching it on .
•
The cut-in and cut-out pressure is preset from the factory and
it is normally not necessary to change this . However, if it is
necessary to change the preset settings, the instructions of this
manual shall be followed carefully .
•
All AC compressors are designed for 100% duty, but 50%
operation is recommended to prolong the lifetime .
•
The fans on the back of the cabinet will start when the
temperature exceeds 30°C . It will run continuously even if the
compressor may have switched of until the temperature is below
30°C again .
•
Do not lubricate the oil-less motor with oil, as it will destroy
important components .
Start
Start the compressor by pressing the green button .
The green lamp for compressor in operation is now
alight .
Read the outlet pressure on the pressure gauge .
Adjust the pressure on the regulator .
Read the receiver pressure on the pressure gauge .
The green lamp is alight when the fans are in operation .
Read on the hour counter the elapsed service time .
If the compressor does not start, there might be pressure in
the receiver . The compressor will automatically start when the
pressure drops .
The compressor will automatically stop when the preset cut-out
pressure is reached .
Stop
Turn off the compressor by pushing the green button .
The green light for compressor in operation switches off .
