EN
67
WARNING
–
Do not operate the appliance, when the sealing ring on
top of the inner tube of the juice collector is missing, damaged, polluted, or not
mounted correctly.
Ensure that the exterior and sealing surfaces of the juice colle-
ctor and the shaft of the squeezing auger are clean and dry, before assembling
the juicing system on the motor base. Otherwise, residues of food and liquids may
get into the motor base and/or cause damage and leakage. At the bottom of the
juice collector the rubber flap seals the pulp outlet. Before operating the appliance,
always ensure that the rubber flap is inserted correctly and firmly in the pulp outlet.
Do not overfill the juice collector to avoid overflow. Do not allow the filling level
in the juice collector move up beyond the upper rim of the separating mesh. Duri-
ng juicing, ensure that juices and pulp run into the containers without obstacles.
Otherwise, caused by overflow of the juice collector, the juice could run on or
under the motor base.
WARNING
– If any liquids run out during operation or are accumulating
under the motor base,
immediately unplug
the appliance.
DO NOT remove the
squeezing auger from the juice collector with the juice collector still mounted
on the motor base
, because this may cause the juices run out onto the motor base.
Always remove the juicing system from the motor base by pulling the juice collector
upwards, before taking out the squeezing auger (see: ‘Care and Cleaning /
Disassembling the Juicing System’).
If liquids have run onto the motor base, clean the motor base and leave the motor
base dry naturally for at least 1 day (see: ‘Solving Problems’ and ‘Care and Clea-
ning’).
Ensure to place the appliance on a suitable, level working space. Always keep the
appliance in a sufficient distance to the edge of the working space and to other
objects.
Due to vibrations during operation, the appliance might move around
on the working space. While the motor is agitating, always have an eye on it.
IMPORTANT -
The motor may operate continuously for max. 15 minutes. Then,
make a break of approx. 30 minutes. For reducing energy consumption and pre-
venting overheating, always switch off the appliance intermediately, while prepa-
ring another portion of food, and when making a break.
ASSEMBLING THE JUICING SYSTEM
1. Place the motor base on a suitable, dry, and clean surface (see: ‘General Safety
Instructions’) with the power switch facing to the right side.
2. Ensure that the dark central sealing ring of the juice collector is clean and undama-
