EN
81
DISASSEMBLING THE JUICING SYSTEM
CAUTION
–
Do not attempt to remove the juicing system (parts that can
be removed from the motor base) with violence
, to avoid damage to the safety
interlocks. Always unlock the juicer cover first.
The squeezing auger seals the cen-
tral tube of the juice collector, thus preventing the juices from running onto the
motor base.
For disassembling the juicing system, always remove the juice colle-
ctor from the motor base with the squeezing auger still in place. To avoid overflow:
Do not let the appliance operate, when the filling level in the juice collector rea-
ched already the upper rim of the separating mesh.
NOTE
It is good advice to hold a sufficiently large tray at hand for placing the parts of
the juicing system on it. This may help to keep your working space clean and dry.
1. If possible and
when overflow of the juice collector may not occur
, let the appli-
ance operate until remaining pieces of food in the feed chute are taken in. Then
switch the power switch to the central position (“O”). Unplug the appliance.
2. To avoid that juices still drip out of the juice spout, close the drip-stop shutter at
the juice spout by folding the drip-stop shutter downwards and push it into the
juice spout.
3. Remove the containers for juice and pulp. Turn the juicer cover counter-clockwise
for unlocking it.
4. With the juicer cover, squeezing auger, filter sleeve and rubber blade sleeve still
mounted, grasp the juice collector at both sides, holding the juicer cover with
your thumbs in place, and pull the juice collector upwards for removing the jui-
cing system from the motor base. Place the juicing system on an even and level
surface that is resistant against water and fruit acids. Remove the pusher and
juicer cover.
5. If the juice collector is still filled with residues of juices and wet pulp: hold the
squeezing auger with your finger in place, while turning the juice collector upsi-
de down over a sufficiently large plastic bowl. Let the runny residues in the juice
collector flow out.
6. Grasp the rim of the filter sleeve and pull the filter sleeve, rubber blade sleeve
and squeezing auger out. Pull off the rubber blade sleeve.
7. Turn the filter sleeve upside down for letting the squeezing auger fall into your
hand.
