EN
84
brush is suited best. Move the used brush in circles.
3. Thoroughly rinse the filter sleeve under running tap water. Then dry the filter slee-
ve and check the result.
4. If the pores are clogged still, repeat the steps 1 to 3.
NOTE
To maintain the performance of the juicer, replace the filter sleeve, when it is
impossible to get the separating mesh free of residues again. Stubborn residues
cannot build-up so easily, when the filter sleeve is cleaned thoroughly always
immediately after juicing.
CLEANING THE MOTOR BASE
1. After operation, always switch off (power switch to the central “O” position)
and unplug the appliance. Remove the juicing system from the motor base (see:
‘Disassembling the Juicing System’). Leave the motor base cool down.
CAUTION
– Always keep the motor base dry. Do not spill or drip any
liquids onto the motor base. Do not use any hard objects to avoid damage to the
surfaces and safety interlocks.
2. For removing any residues and splashes, wipe the exterior of the motor base
and power cord with a slightly damped, soft cloth. Ensure that liquids do not run
onto the motor base.
3. After cleaning, polish with a soft dry cloth and leave the motor base dry naturally
for approx. 30 minutes, where the motor base and power cord are
out of reach
of children younger than 8 years and animals
.
STORAGE
WARNING
–
Do not let children play with the appliance or any part of
it.
When the appliance is not in use, always turn the power switch to the central
“O” position and unplug the appliance.
Do not leave the motor base connected
to the power supply, while it is not in use.
Do not hold the appliance by the power cord, drive rotor, juicer post, or any part
of the juicing system for moving the appliance to avoid damage. Instead, grasp the
motor base at both sides. The power cord may never be knotted, twisted, pulled,
strained or squeezed. Do not let the power plug or power cord hang over the edge
of the table or board.
