52
disc and shaft. Thereafter pour out the juice. If you wish to continue processing, replace shaft
and cutting disc and re-assemble the lid. Wipe off all spilled liquids or food carefully from
the exterior of the bowl. Then, replace the bowl on the motor base and lock bowl and lid.
Thereafter, you can connect the appliance to the power supply again and continue working
quite usually.
15. After you have processed your food as desired, switch OFF and unplug the appliance.
Continue as described in section „After Processing“. Clean the appliance and all used parts
and accessories immediately after use. Do not let any food dry on the surfaces.
After processing
After processing your food, remove the bowl from the motor base and take your food out of
the bowl.
WARNING:
Switch OFF the appliance first (indicator of the ON/OFF button goes out), then
unplug the appliance, if you do not use the appliance or assemble/disassemble any parts or
accessories, or for cleaning or moving the appliance. Do not leave the appliance unatten-
ded, when connected to the power supply.
Always ensure that the appliance and any parts and accessories of it are out of reach of
young children.
Do not grasp in the bowl or insert any foreign objects (e.g. cooking utensils) with the bowl
mounted on the motor base and the appliance connected to the power supply. Always
remove the bowl from the motor base, before emptying and/or cleaning. The blades of the
cutting tools are very sharp. Handle with care to avoid injuries.
Do not use any violence. Bowl and lid are locked on the motor base for operation. Thus you
must unlock these parts by turning them counter-clockwise before you can remove them.
Remainder of food and liquids could drop from the parts of the appliance, when disassem-
bling. Ensure that no liquids drip on the motor base or any other delicate objects, when
removing the lid. Always clean the appliance and all used parts and accessories after each
usage according to the instructions in section Care and Cleaning. Do not let any food dry on
the surfaces.
1. When you finished your work, switch OFF (indicator goes out) and unplug the appliance.
2. If you have used the large lid and jug, remove the jug from under the outlet. For this, tilt
the jug a little, but take care not to spill the contents of the jug.
Tip:
Always ensure to hold the bowl level, when removing it from the motor base to avoid
spilling the contents. This holds especially when the bowl is quite full.
3. Grasp the handle of the bowl, turn the bowl counter-clockwise to the stop, and then,
holding the bowl level, lift it carefully straight upwards. Place the bowl on a stable, level and
water-resistant surface.
4. Remove the lid from the bowl. For this, hold the bowl by the handle while turning the lid
counter-clockwise to the stop. Then remove the lid.
5. Remove the tools you have used, from the bowl.
• If you have used a cutting disc, then grasp the central plastic part and pull out the
disc. Maybe the shaft sticks to the disc and comes out with it.
• After working with the large lid with outlet: remove the separator disc.
Summary of Contents for 40963 DesignFood Processor S
Page 27: ......
