appliance directly to a separately protected mains power supply wall socket with protective
conductor (earth/ground) connected properly. Do not use any extension cord or multi socket
outlet. The installation of a residual current safety switch with a maximum rated residual
operating current of 30 mA in the supplying electrical circuit is recommended. If in doubt,
contact your electrician for further information.
• In various foreign countries, the specifications for power supplies are subject to incom
-
patible norms. Therefore it is possible that power supplies in foreign countries do not meat
the requirements for safe operation of the appliance. Thus, before operating the appliance
abroad, ensure that safe operation is possible.
• Always handle the power cord with care. The power cord may never be knotted, twisted
or squeezed. Do not pull or strain the power cord. Do not let the plug or power cord hang
over the edge of the table or counter. Take care that no one will pull the appliance by the
power cord, especially when young children are near. Always grasp the plug to disconnect
the power cord from the power outlet. Do not touch the plug or power base with wet hands,
when the plug is connected to the power supply.
• Before operation completely unwind the power cord, insert the power cord in the gap on
the bottom of the power base, and ensure that the power base will not tilt or wobble during
operation. Do not place the kettle or power base on the power cord.
• Always switch off the kettle and unplug the power base from the power outlet when not in
use and before moving or cleaning the power base. Do not leave the power base unatten-
ded while connected to the power supply. Never leave the appliance unattended when in
operational mode.
• When the power cord warms up during operation or is likely to be damaged, it must be
replaced by an authorised service centre. Do not attempt to repair the power cord!
• Do not immerse the kettle, power base or power cord in water or any other liquid. Do not
spill or drip any liquids on the power base, power cord or switch area of the kettle to avoid
risk of fire and electric shock. When liquids are spilled on the exterior of the appliance or
condensate has built up on the power base, immediately switch off the kettle, unplug the
power base and dry the appliance.
tECHNICAl SPECIfICAtIONS
Model:
Art.-No. 42428 Design Kettle Pro
Power supply:
230-240 V, 50 Hz
Power consumption:
2,200-2,400 W
length of power cord:
approx. 94 cm
Weight:
approx. 1.3 kg
Dimensions:
approx. 210 x 165 x 230 mm
(width x depth x height)
Certification:
19
Summary of Contents for 42428
Page 23: ...Notizen Notes...
