31
• Do not place the appliance or any part of it on or near hot surfaces (e.g. burner, heater or
oven). Do not use any parts of the appliance with any other device or for any other purpose.
Before operation, always ensure that the appliance is assembled completely
and correctly according to the instructions in this booklet.
Do not handle the appli-
ance or any part of it with violence.
• Do not insert your fingers or any foreign objects (e.g. clothes, cooking utensils) in the bean
hopper or milling works, with the appliance connected to the power supply. Do not use any
hard, sharp or edged objects (e.g. knives, forks, cleaning brush) with the appliance.
• It is best to close the bean hopper lid securely before operation. Do not open the bean
hopper lid during operation.
• Do not leave the appliance unattended, when it is connected to the power supply. Always
switch off (with the milling works running: press the START | PAUSE | CANCEL button) then un
-
plug the appliance, before moving, or cleaning the appliance, or assembling or disassembling
any parts, or when the appliance is not in use. Always hold the power base at both sides near
the bottom for moving or lifting.
Do not hold the appliance at the bean hopper lid,
power cord, or bean hopper for moving the appliance.
Do not place any hard
and/or heavy objects on the appliance or any part of it.
• Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any corro
-
sive chemicals (e.g. bleach) for cleaning. Do not immerse the power base or power cord in
water or any other liquid. Do not spill or drip any liquids on the power base or on the power
cord to avoid risk of fire and electric shock.
Do not place the appliance or any part of
it or power cord in an automatic dishwasher.
Important safeguards for electrical Appliances
The appliance is driven electrically. Place the appliance near a suitable wall power socket to
connect the appliance directly to a protected mains power supply with protective conductor
(earth/ground) connected properly. Ensure that the voltage rating of your mains power supply
corresponds to the voltage requirements of the appliance (220 - 240 V, 50 Hz, AC, rated for
at least 8 A).
The installation of a residual current operated circuit breaker (r.c.c.b.) with a maximum rated
residual operating current of 30 mA in the supplying electrical circuit is strongly recommen-
ded. If in doubt, contact your electrician for further information.
In various foreign countries, the specifications for power supplies are subject to incompatible
norms. Therefore it is possible that power supplies in foreign countries do not meet the requi-
rements for safe operation of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible.
• Do not to use any desk top multi socket outlet, external timer, or remote control systems.
It is best to avoid using extension cords, but if you wish to use one, only use an extension
cord rated for a maximum continuous current of at least 8 A with protective conductor (earth/
ground) connected properly.
• Always handle power cords with care. Always completely unwind the power cord before
use. Do not place the appliance on a power cord. Power cords may never be knotted, twisted,
pulled, strained or squeezed. Do not let the plug or power cord hang over the edge of the
table or counter. The power cord may not touch hot surfaces or sharp edges. Ensure that no
one will pull the appliance by the power cord. Take care not to entangle in the power cord.
