Gastroback 61150 Operating Instructions Manual Download

Page: 7 / 16

PROPERTIES OF YOUR NEW CITRUS JUICER

The

CITRUS JUICER ADVANCED PRO S

is equipped with patented juicing mecha-

nics enabling efficient operation without applying much force. You simply move

down the designated lever (press arm). The whole work is done by the powerful

motor. The hard-wearing large sized juicing cone is made of die-cast aluminium and

scrapes the pulp out of the fruit halves, thus squeezing out the juice. According to its

extraordinary size, even large types of fruit can be squeezed (up to 12 cm in dia-

meter: e.g. grapefruit) as well as small fruit (e.g. tangerines, lemons). During squee-

zing, the fruit dome is lowered via the press arm onto the fruit halves, squeezing the

complete fruit half in a single step without effort for getting the optimum juice amount.
• Two stainless steel filter baskets with different strainers (coarse and fine) are desi-

gned for getting juice with more or less fruit pulp.

• The motor starts by simply applying pressure to the fruit halves via the fruit dome.

The juice drips into the juice collector. The drip-stop feature at the juice spout

helps keeping your workspace clean. Before removing your juice vessel from

under the juice spout, simply fold up the juice spout for closing the juice outlet.

• All parts coming in direct contact with food can be removed in a trice without effort.

After usage, you may clean these parts conveniently in an automatic dishwasher.

• There are no gaps and useless grooves in the smooth top plate of the motor

base, allowing easy cleaning.

OVERHEAT PROTECTION

The

CITRUS JUICER ADVANCED PRO S

is equipped with an overheat protection

system, automatically cutting off the power supply, when the temperature of the

appliance gets too high.
Overheating may occur in the following cases:
• The appliance ran in continuous operation for an elongated time. Slow down

your juicing action. Do not operate the appliance continuously for more than 5

minutes. In time, make breaks of some minutes.

• Too heavy load via pushing down the press arm with too much force.
• Perhaps, the juicing cone is stuck. Ensure that no seeds are caught between the

juicing cone and the strainer of the filter basket (see: ‘Operation / Emptying the

Filter Basket and Removing Obstacles’).

If the citrus juicer unexpectedly stops running,

unplug the appliance

and check for

any obstacles. Remove the obstacle.
• Check whether the drive shaft can be turned manually via the juicing cone. A

slight resistance is normal. If the juicing cone is blocked, empty the filter basket

(see: ‘Operation / Emptying the Filter Basket and Removing Obstacles’).

• Check, if the appliance is assembled correctly. The juice collector must be placed

on the top plate of the motor base without any gap all over. Only one separate

filter basket may be installed (see: ‘Operation / Assembling the Appliance’).

• Check, if the filter basket is deformed or broken. If required, replace the filter