EN
48
Problem
Mögliche Ursache
Die einfache Lösung
Using the storage contai-
ner:
The grind time is set
to “0”.
For grinding into the storage container, you must set a
sufficient grind time.
Filling a portafilter:
The
portafilter cradle is missing
or not installed correctly.
Slide the portafilter cradle into the runners directly below
the grinder outlet and push the portafilter cradle to the
rear wall of the grinder cavity to the stop.
Filling a portafilter:
The
portafilter is not installed
correctly.
Below the portafilter cradle
, push the portafilter into
the grinder cavity until the grinder starts.
A severe problem occur-
red.
Get in contact with an authorized service centre for exa-
mination and repair.
The storage container does
not fit in the grinder cavity.
The storage container is in
wrong orientation.
When inserting the storage container, the filling hole in the
container lid must face to the rear wall of the grinder cavity.
A portafilter cradle is
installed.
Remove the portafilter cradle. Then try again.
The latch at the container
lid is still closed.
Open the black latch and turn it to the well in the contai-
ner lid. Then try again.
Ground coffee spills from
the storage container.
The powder tray is missing. Always install the powder tray, when grinding into the
storage container.
The storage container is
overfilled.
Before operation, always ensure that there is sufficient
free space left in the storage container. The build-up of
heaps in the storage container may cause overflow, even
when the container is not filled completely. We recom-
mend to empty the storage container completely, before
grinding another portion.
Electrostatic charge may
be the cause, especially,
when a very fine grind
size is selected.
This problem may occur with inclement weather and fine
grind size. The problem may be reduced, when wiping the
exterior
of the storage container via a slightly damp cloth.
Avoid wiping the collection container via any dry cloth made
of synthetics. For cleaning, prefer a cloth made of linen.
The usual amount is not
given off, and/or the
grinder makes an unusual
noise.
You changed the grind
size.
After changing the grind size, it may be necessary to
adapt the grind time accordingly (see: ‘Operation / Set-
ting the Amount’).
Not enough coffee beans
in the bean hopper.
Fill the bean hopper.
