35
assemBling the juicer
Before first use, clean all removable parts of the juicer in warm soapy water (see ›care
and cleaning‹). For assembling please refer to the figures above (see ›Get know your
Juicer‹).
Warning:
Please handle with care. there are extremely sharp cutting blades in
the base of the filter basket and a sharp protrusion in the feed chute. Before you plug in
the juicer, always ensure that the appliance is assembled correctly.
1. Place the juice collector on the top of the motor base.
2. lock the juice collector by pushing it slightly down and rotating
it counter-clockwise as far as possible without violation.
3. insert the filter basket inside the juice collector. rotate the filter
basket in the juice collector until it is seated on the gear. the
upper edge of the filter basket may not protrude the juice coll-
ector.
caution:
rotate the filter basket to ensure that it is mounted
properly and will not wobble or tilt. the filter basket must rotate
easily and without rubbing on the juice collector.
4. Place the juicer cover over the juice collector. the juicer cover
can only be mounted in the correct orientation: the feed chute
must be centred above the filter basket, the juicer cover must
seat firmly on the rim of the juice collector and the safety cover
lock slips into the locking slot of the juice collector.
5. rotate the juicer cover clockwise until the safety cover lock
slips into the locking slot of the juice collector.
6. Place the pulp container into position on the left side of the
motor base (see figure XX).
tip:
to minimize washing up we recommend to place a plastic
freezer bag into the pulp container to collect the pulp.
