SL320000819 Ed.12 - 07-2013
- 13_EN -
If the decimal point viewed is on the left, the temperature reading refers to the
tank 1 (see Fig.2 Page 5).
If the decimal point viewed is in the centre, the temperature reading refers to the
tank 2 (see Fig.2, Page 5).
If the decimal point viewed is on the right, the temperature reading refers to the
tank 3 (see Fig.2, Page 5).
Note: If while using machine, the electronic thermostat should
switch off suddenly, to start it again press the
. key. If the
electronic thermostat should not switch on again, switch off the
machine and contact your nearest assistance centre.
Important: While using the machine, the electronic thermostat
must always be on so as to show the temperature of the product
in the tanks.
6.7. Starting the Granita Maker 2/3 (Electronic thermostat)
Switch (A) in position “I“: Machine powered.
Switch (B) in position “I“: Mixers operating.
To make SLUSH DRINKS (GRANITA):
Deviators (D) in position “I“: Refrigerator system operating (slush drinks - granita).
To make COLD DRINKS:
Deviators (D) in position “II“: Refrigerator system operating (cold drinks).
To disable the FRIDGE (mixing only):
Deviators (D) in position “0“:Refrigerator system off (mixing only).
ALARMS
In case of probe failure, the display will show the following alarm messages:
“A1”: Tank 1 probe disconnected
“A2”: Tank 1 probe short circuit
“A3”: Tank 2 probe disconnected
“A4”: Tank 2 probe short circuit
“A5”: Tank 3 probe disconnected
“A6”: Tank 3 probe short circuit
During operation, the electronic thermostat shows the temperature of the prod-
uct in the tanks, cyclically showing the temperature of the product fi rst in one
tank and then in the other, every 3 seconds.
To see which tank is referred to with the temperature reading, it is necessary to
check which decimal point is being shown.
Fig.30
2 TANKS
Fig.31
3 TANKS
Fig.29
A
C
D
D
B
B
A
C
D
D
B
B
D
B
Fig.28
2 TANKS
3 TANKS
Summary of Contents for GRANISMART 1
Page 164: ......
