- 23 -
Once the SPEED menu has been accessed, Speed Source can
be selected as either Vehicle or GPS. If Vehicle is selected
please consult the documentation which came with your
vehicle to see how to set up this connection, as this method is
not supported by Gatekeeper Systems INC.
If an approved GPS module has been fitted select GPS as the
Speed Source.
Speed Unit can be set to either MPH or KPH, select the
correct Speed Unit for your location.
To enable Speed check select the EN (short for Enable) menu and set to ON.
Next for either LOWSPEED or OVERSPEED set the THRESHOLD value. Use the Numeric keypad on the remote
control to set the required values.
To have an Alarm be registered when the THRESHOLD value has been reached or exceeded, set the ALARM option
to ON.
Once all selections have been made, highlight the OK button and press ENTER on the remote control.
Format Card
Under the Format Card menu there is only one option to choose, and this
is listed under the Function Option.
Function Options are FAST FORMAT (Approximately 2 minutes to format
a 32GB SD card) or SLOW FORMAT (Approximately 4 minutes to format
a 32GB SD card).
Once the required Function option has been Selected, Highlight the OK button and press the ENTER button on the
remote control.
A dialog window will appear requiring User Confirmation and warning “All data will be deleted after formatting”. Click the
OK button to confirm or the CANCEL button to exit the format and return to the Format option window.
If OK has been chosen, a dialog box will appear stating “Formatting, Please wait”. Once formatting has completed a
different dialog window will appear stating “Format Successfully, please restart”, press ENTER on the remote control to
restart the 304SD. A confirmation window will appear stating that the 304-SD is restarting.
NOTE: If a SD card has been formatted in a PC or another device, it MUST be formatted in the 304-SD. In order to increase
reliability as a custom file system is utilized by the 304-SD. The SD card must be formatted on the 304-SD or no video will be
recorded.
Reboot DVR
On some occasions, such as after changing the Shut Down
Delay setting, it is beneficial to restart the DVR for the option to
take effect immediately. Once the option window, shown on the
right, appears use the UP arrow on the remote control and
highlight NO. A drop down menu will appear, select YES. Use the
Down arrow on the remote control to Highlight OK and then
press the ENTER button on the remote control. Once the ENTER
button has been pressed a Dialog window will appear stating
“MDVR will restart, (OK/Cancel)” with the OK button highlighted
press the ENTER button on the remote control.
Please Note: There will be a time delay between the pressing of the OK button and the restarting of the DVR, this is due
to the DVR finalizing the writing of Video to the SD card.
