30
WIFI
Wi-Fi can be configured for use of an internal Wi-Fi card, if installed, or for when an external Wi-Fi radio is being utilized. If an
external Wi-Fi radio is being used Wi-Fi ENABLE must be set to OFF.
If an internal wireless module is being utilized, please consult with your Information Technology department for all relevant IP; DNS;
Gateway and subnet information.
If Wi-Fi is enabled, I.E. using an internal Wi-Fi card, there are two
options once enable has been selected:
Client:
Sets the 816-HD as a client on the network. Once
selected GET IP Type will become available with two
options; Static IP and Dynamic IP.
If Static is chosen complete the required fields for IP;
SUB; and Gateway.
ESSID:
ESSID only becomes active once the PASSWORD
ENABLE option has been chosen. Enter the required
ESSID, network name, for the wireless network.
Figure 13: WI-FI Settings.
PASSWORD ENABLE
Options:
NONE/WEP/WPA
MOBILE NETWORK.
Please note: This function is currently reserved for future development.
If a mobile network is to be configured, the 816-HD will require the installation of a SIM card, this must be done at time of
purchase of the 816-HD from Gatekeeper Systems as disassembly of the 816-HD in the field will void the warranty.
Module Type
Options
NONE; CDMA; EVDO; WCDMA; EDGE; TD-SCDMA
If EVDO is chosen, a secondary dialog window will appear with options for 2G3G / 2G / 3G.
Default: None
Active Mode
Options
Always; Call/SMS; Sensor. If Call/SMS is selected a secondary dialog window will appear
where up-to three phone numbers can be entered.
Dial Parameter
Intercom Settings
Reserved for future development.
FTP SETTINGS
Not Supported
