32
SPEED
There are numerous options available for setting within the Speed option. Some of these options are only available after other
selections have been made. Please Note: An approved GPS antenna is required for the 816-HD to receive satellite signals for
speed.
Once the SPEED menu has been accessed, Speed Source can be selected
as either Vehicle or GPS. If Vehicle is selected please consult the
documentation which came with your vehicle to see how to set up this
connection.
If an approved GPS module has been fitted select GPS as the Speed
Source.
Speed Unit can be set to either MPH or KPH, select the correct Speed
Unit for your location.
To enable Speed check select the Enable menu and set to ON.
Next for either LOWSPEED or OVERSPEED set the THRESHOLD value. Use
the Numeric keypad on the remote control to set the required values.
To have an Alarm be registered when the THRESHOLD value has been
reached or exceeded, set the ALARM option to ON.
Once all selections have been made, highlight the OK button and press
ENTER on the remote control.
Figure 15: Speed.
ACCELERATION
.
The 816-HD has been fitted with an internal Inertia, G, Sensor. This can
be setup with independent values for X, Y and Z axis, these can be set to
the requirements of the individual customer.
The Inertia sensor can be setup by accessing System
Event
Acceleration.
To enable select ON from the OVERSHOCK SHK drop down box. Enter
the relevant values.
If there’s a requirement for an arm to be triggered if the pre-set values
have been exceeded, then change the ALARM drop down from OFF to
ON.
Figure 16: Acceleration.
