G4-304SD1a
User Manual & Install Guide
126 of 151
Alarm
Trigger
Click the
( Setup )
button under Trigger to
display the Trigger setup screen to setup the G
Sensor threshold values:
X
– numeric text field to set the
threshold value for the G forces along
the x-axis.
Y
– numeric text field to set the
threshold value for the G forces along
the y-axis.
Z
– numeric text field to set the
threshold value for the G forces along
the z-axis.
DEFAULT SETTINGS:
Disabled.
Linkage
Click the
( Setup )
button under Linkage to go
to the Linkage setup screen. This sets up the
video display, recording and snapshot options
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel
– checkboxes which allow
you to select any combination of the
camera channels to be included in the
display and recording.
Post Recording
– drop list which
allows you to select the duration for
which video will continue to be
recorded when the alarm is triggered.
Lock
– checkbox, if selected will mark
the recorded video associated with
this alarm as locked video.
Linkage IO Output
– checkboxes, if
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time
– numeric text
field to set the delay time for the IO
output (in seconds).
Linkage Screen
– drop list to select
the options to display the video from
the selected cameras on-screen when
the alarm occurs.
