G4-304SD1a
User Manual & Install Guide
42 of 151
-
Channels 1 to 4 are analog channels.
-
Channel 5 is a Digital IP camera channel.
Enable
For channels 1 to 4, only enable the channels
which actually have cameras connected. Please
note that the system will show a video loss
message on channels which are enabled, but
do not have a connected camera (i.e., no
incoming video stream).
Likewise, for channel 5 (Digital IP Camera
channel), only enable this channel if it actually
has a camera connected.
Resolution
DEFAULT SETTINGS:
For channels 1 to 4 (analog camera channels),
set the following:
D1
For channels 5 (IP camera channel), set the
following:
720P
Frame Rate
DEFAULT SETTINGS:
For all channels (1 to 12), set the following:
15
Quality
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
1 (Best)
Record Mode
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
Power Up
Audio
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
Checkbox – Selected
Alarm Quality
DEFAULT SETTINGS:
For all channels (1 to 5), set the following:
