SUPERLOCK DIGITAL
SINGLE SIDED
© Copyright Gatemaster 2016
SPECIFICATION
SHEET
193
+44 (0)1243 552066
www.signetlocks.co.uk
VISIT SIGNETLOCKS.CO.UK FOR MORE INFORMATION
LOCK CODE:
C
_
_
_
_
_
TO CHANGE THE CODE
1.
Check the original code is working on the keypad.
2.
Remove the keypad off the lock. To do this, slide the keypads and lock insides out of the
case spine and unscrew the two screws fixing the keypad to the panel.
3.
Turn the keypad over and remove the 4 screws.
4.
Lift off the covering panel carefully as there are 10 springs attached to this panel. Note that
the red tumblers relate to the code shown above. Also note that the C tumbler is uncoloured
and should not be removed.
5.
To change the code hold the keypad with the code buttons down and depress & hold the C
button (if this is not done you may damage some of the internal components). Reposition the
tumblers to the new code (red tumblers are coded and blue tumblers are uncoded). Ensure
that the square cut-out on each tumbler is facing the outside of the lock body, also ensure
that the coloured mark is facing upwards. If any one tumbler is upside down or the wrong
way round the lock will not work and if forced will break the internal components. The code
must always start with a ‘C’
6.
Replace the covering panel and tighten the 2 screws
7.
The code is now changed, check to see that it is working correctly and make a note of the
code for future reference. Once satisfied that the lock is working correctly refit keypads to
the panel using the 2 screws and reassemble the lock.
MAINTENANCE
3 monthly:
1. Remove keypads from the lock
2. Spray the inside of the lock thoroughly with WD40 or equivalent, through the tum-
bler holes at the back of the lock
3. Spray all the fixing accessories and the latch with WD40 or equivalent.
Push each of the buttons and rotate the knob several times to make sure the lock is
working smoothly
