DEEP EPIC Setup
Page 24
External Monitors
Two monitor options are available for use with DEEP EPIC: the RED 5.6 in and RED
PRO 5 in.
RED 5.6 in External Monitor
Open the case.
Remove the 4 screws that secure the back to the monitor shell.
Clean the window / LCD.
If necessary, clean the inside of the window and blow
out any foreign matter. Clean the LCD screen as well.
Connector.
Plug in the LCD connector. Be sure it is fully seated to the LCD.
Install the LCD.
The RED LCD will insert face down (against the window) with the
connector facing the rear. Insert the left edge first (closest to the wire).
It should
rest inside the shell without obstruction.
Inspect the o-ring.
As always, inspect the o-ring for foreign matter. Wipe your
finger around the silicone o-ring to clear away any dirt, hair, etc. DO NOT
LUBRICATE the silicone o-ring.
Remove 4 screws to
open the LCD
Monitor shell.
Plug in the LCD cable, then insert the
LCD into the shell. Lead with the edge
closest to the wire first.
Inspect the o-ring. Wipe clean with your
finger to remove foreign material. DO
NOT lubricate orange o-rings.