Make sure cylinder is locked into position by placing
lock pin into hole on top of cylinder.
BEGIN THE CRIMP
Start by steadying hose with one hand while
pressing and holding the power “on” switch
withthe other hand, which extends the ram
(seepump operation manual for switch location).
When light comes on and buzzer sounds,
IMMEDIATELY release the power “on” switch.
NOTE: If light and buzzer become faint or do not
work, the controller batteries may need replacement.
See Maintenance Section.
REMOVE HOSE ASSEMBLY
While holding hose, lightly lift bottom of die set
to release hose assembly.
Remove hose assembly.
Serious injury and/ or crimper damage can result
if the cylinder is not locked in its
crimp position.
LOCK PIN
Keep away from all moving parts! If bodily contact
with a moving part occurs, immediately release the
pump power “on” switch.
CAUTION
INCORRECT
CORRECT
OPERATING INSTRUCTIONS
MOBILE CRIMP 4-20 SAFETY AND OPERATING MANUAL
7.
8.
IMPORTANT
14
