T1 CrossConnect Installation & Operation Manual
3 – Installation & Wiring
Version 2
3-2
GatesAir
Intraplex Products
Warning!
Follow all of your company's rules regarding AC- or DC-powered equipment installations. If
there is a conflict between any procedure in this manual and your company's safety rules,
your company's safety rules must take priority.
3.3 CrossConnect System and Server Installation
The CrossConnect products are normally shipped pre-configured, with common and channel modules
already installed. All modules and module adapters can remain in place while bolting the shelf into its
equipment rack. To install the CrossConnect equipment, perform these steps:
1.
Make sure all modules and module adapters are seated properly.
2.
Bolt the shelf into its equipment rack.
Note:
If the shelf is AC-powered, make sure that the power cable is accessible for maintenance
purposes.
Figure 3-1. DCS-9500 Dimensions
Figure 3-2. DCS-9530/9560/9565 Dimensions
The DCS-9530/9560/9565 can contain a second power supply for redundancy. If the main supply fails,
the system continues operating using the redundant supply. To install the redundant power supply,
perform these steps:
Summary of Contents for Intraplex T1 DCS-9530 CrossConnect System
Page 2: ......