T1 CrossConnect Installation & Operation Manual
5 – Configuration Using IntraGuide
Version 2
5-6
GatesAir
Intraplex Products
Figure 5-5. CM-95, Configuration Pane
5.3.3
Auto Detect
When you run Auto Detect, you can specify the full range of addresses for the devices in your system,
from the first address to the last, but the discovery process takes longer than if you run Auto Detect in
several discovery sessions with smaller address ranges.
To run Auto Detect to discover all the devices in the network, perform these steps:
1.
On the menu bar, click
Setup
.
2.
Point to
Device
Configuration
and click
Auto
Detect
Devices
. The
Device
Discover
Wizard
dialog box appears (Figure 5-6).
Summary of Contents for Intraplex T1 DCS-9530 CrossConnect System
Page 2: ......