32
Chapter 4: Operating the Autoloader
www.gateway.com
Menu options
Press the
E
NTER
button to access the menu options from the Operator’s Panel.
Use the
P
REVIOUS
and
N
EXT
buttons to navigate through the menu items, then
press
E
NTER
to select the menu item. Use the
C
ANCEL
button to cancel the last
action and return to the previous menu item.
For most installations, the default configuration for the autoloader does not
need to be changed. However, you can access the Configuration menu from
the Operator’s Panel to change the SCSI IDs for the autoloader and the tape
drive.
Important
The autoloader and the tape drive must each have unique
SCSI IDs. Make sure that you do not assign duplicate IDs
within a bus. For more information on changing SCSI IDs,
see “SCSI ID settings” on page 52.
Commands
Information
Configuration
Diagnostic
Import
Export
Load cartridge
Unload
cartridge
Clean drive
Re-Inventory
Cycle count
View event log
Product Rev.
Serial numbers
Firmware
revisions
Reset
Change SCSI
ID
Code update
Circular mode
Autoload mode
System test
