57
Power specifications
www.gateway.com
Power specifications
AC power
The autoloader has automatic AC input voltage selection and accepts the input
voltages shown in the following table. The autoloader is capable of continuous
operation when the AC power experiences intermittent operation, voltage
surges, and voltage spikes.
AC power cord
The autoloader comes with a 7-foot (2.1-meter), three-conductor, 18 AWG
power cord for 120 volt use in the United States and Canada. The power cord
has a molded NEMA 5-15P connector on one end and a molded IEC 320/EN
60320 connector on the other end. The power cord is UL Listed and CSA
Certified.
United States and Canada — 120 VAC power cord
■
The power cord must have a molded NEMA 6-15P attachment plug on one
end.
■
The power cord must have a molded EC 320/EN 60320 connector on the
other end.
■
The cordage must be an SJT or SVT type, 3-conductor, 18 AWG minimum.
■
The power cord must comply with local electrical code.
Input voltage
100 to 240 V AC ±10%,47 to 63 Hz
Input voltage
100 to 240V AC ±10%, 47 to 63 Hz
Power consumption:
■
Average while idle
■
Average while operating
■
Maximum while operating
■
Average heat output while operating (based
on the AC true power consumption)
■
20 watts
■
35 watts
■
70 watts
■
119.4 BTU/hour
