66
www.gateway.com
Chapter 4: Installing Components
Installing memory
When you upgrade your server memory, make sure that you install the correct type of
memory in your server. Your server supports from 256 MB to 16 GB total memory.
Supported DIMM sizes include 256 MB, 512 MB, 1 GB, and 2 GB.
The BIOS configures the memory controller to run in either single channel or dual channel
mode, depending on the following:
■
If one or more fully populated DIMM banks are detected, the memory controller
will run in dual channel mode.
■
If only a single DIMM is present, the memory controller will run in single channel
mode.
DIMM banks must be populated using the following guidelines:
■
DIMM banks must be populated in order, starting with Bank 1.
■
Dual rank DIMMs must be populated before single rank DIMMs.
■
When using Dual Rank (double row) DIMMs, a maximum of four loads per memory
channel is supported, therefore a maximum of four dual rank DIMMs can be
populated on this system board.
Caution
Memory modules must be identical in each bank. Use only
DDR2-400 MHz, ECC registered, 240-pin DIMM memory modules in
256 MB, 512 MB, 1 GB, or 2 GB sizes.
Memory modules must be installed in pairs, to completely fill each
bank, and the banks must be filled in order. If you have memory
installed incorrectly, your server will not start up.
DIMM slot 4B
DIMM slot 4A
DIMM slot 3B
DIMM slot 3A
DIMM slot 2B
DIMM slot 2A
DIMM slot 1B
DIMM slot 1A
8510725.book Page 66 Tuesday, May 17, 2005 5:45 PM
Summary of Contents for 9510
