66
www.gateway.com
Installing a tape drive
Tape drive installation requires:
■
A tape drive installation kit
■
A 3.5-inch SCSI tape drive
■
Either a SATA or SCSI backplane already installed in your server
To install a tape drive:
1
Follow the instructions in
“Preventing static electricity discharge” on page 43
. Make
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in
“Opening the server case” on page 44
.
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
Important
Although the power and SCSI cables for the tape drive are not
included with your server, they can be purchased from Gateway.
Important
A tape drive can only be installed in your server if a sixth hard drive
(and the sixth drive board) is not already installed. The installed tape
drive will occupy the sixth drive bay and the space above it (covered
initially by the tape drive filler panel).
Summary of Contents for 9515
